Easy and convenient installation and operation of rubber flexible joints

The replacement method of rubber flexible joints: first measure the length after the original disassembly, and purchase the corresponding length and compensation amount. After clearing the pipeline substance, cut off the compensator with oxygen cut or remove the foot bolt on the compensator, dismantle the original if the metal hose immediately interconnects with the server belongs to the forced connection, when the server vibrates then the tube will be destroyed such as pulling Shen, etc., with the development of conductive flexible connection, which can offset the vibration, maintain the tube, reduce the assembly deviation on the occurrence, and facilitate the assembly. In addition, can clear the metal hose within the liquid heat up and cold shrinkage utility, in the pump inlet and outlet pipes assembled on the versatility to pipeline thermal deformation, reduce the pipeline to the pump push, or digest and absorb the vibration occurred in the pump operation.
Usually, the liquid through the fan, refrigeration compressor, pump and heating furnace and other increased pressure, from the high pressure of the pipeline into the low voltage, but also can use the liquid itself pressure or heavy transport. Allocate engineering drawings and technical documents, when writing engineering construction plans. Verify the quality of the raw materials of the pipeline and carry out the appearance inspection. Decoration partition non-simultaneous repair of or system software, plus blind. The internal structure of the pipeline is blown and replaced neatly, and the construction site meets the relevant requirements.
The rubber flexible joint is lighter in weight, superior in characteristics, novel in construction, easy and convenient in installation and operation, very good in sealing effect, and the sealing compressive strength can be adjusted in accordance with ease. One end of the flange is connected to the flange on the pipe or the flange of the valve fitting, and the other end inserts the pipe into the bearing port. The insertion length should be slightly less than the total length of the goods. The insertion length can be waymarked in advance at the insertion end of the pipe. It is the connection piece between the pipe and the gate valve. A combination of equipment used to transport gases, liquids or liquids with solid particulate matter.