Below is a guide to disassembling an electrical conduit rubber joint:

When disassembling an electrical conduit rubber joint, it is important to follow proper procedures to ensure safety and prevent damage to the joint and surrounding equipment. Here are the steps to disassemble the joint:
Turn off the power supply: Before starting the disassembly process, make sure to turn off the power supply to the electrical conduit to eliminate the risk of electrical hazards.
Loosen clamping mechanisms: Depending on the design of the rubber joint, there may be clamping mechanisms, such as bolts or latches, securing the joint in place. Use the appropriate tools to loosen these clamps and remove any fasteners holding the joint in position.
Inspect for seals and gaskets: Check for any seals or gaskets that are present around the joint. If the joint is sealed with rubber gaskets or O-rings, carefully remove them to prevent damage.
Release tension: It is essential to release any tension or pressure within the joint before attempting to disassemble it. This can be done by gently manipulating the joint to relieve any built-up stress.Detach the joint from the conduit: Once any clamps, seals, and tension are released, carefully detach the rubber joint from the electrical conduit. It is important to avoid applying excessive force or causing any twisting motion that could damage the joint or the conduit.
Inspect for damage: After the joint is removed, inspect it for any signs of damage, wear, or deterioration. Pay attention to any areas of rubber degradation, cracking, or brittleness, as these may indicate the need for replacement.
Clean the joint and conduit: Use a mild cleaning solution to remove any dirt, debris, or residue from both the rubber joint and the electrical conduit. This will help prepare the surfaces for reassembly and ensure a proper seal when the joint is reinstalled.
By following these steps, you can safely and effectively disassemble an electrical conduit rubber joint. Always exercise caution and refer to the manufacturer's guidelines or consult with a professional if you have any doubts about the disassembly process.