Rubber band metal joints

Rubber band metal joints can be disassembled in a few simple steps. The following instructions will guide you through the process in English.
Firstly, locate the metal joint on the rubber band. It will usually be a small metal piece that connects the two ends of the rubber band. Depending on the type of joint, it might be a hook or a clasp.
Using a pair of needle-nose pliers, carefully grip the metal joint. Apply gentle pressure to separate the two ends of the rubber band from the metal. If the joint is a hook, you might need to maneuver the pliers to unhook the connection. Be cautious to avoid damaging the rubber band or the metal joint during this process.
If the joint is a clasp, look for a small lever or button that may need to be pressed to release the connection. Once you have located the release mechanism, apply the necessary pressure to disengage the joint. Again, be careful not to cause any harm to the rubber band or the metal piece.
In case the joint is secured by adhesive, you may need to use a solvent to weaken the bond. Gently apply the solvent to the adhesive and allow it to penetrate for a few minutes. Then, carefully pry apart the metal joint from the rubber band using the needle-nose pliers.
After the metal joint has been successfully disconnected from the rubber band, inspect both the rubber and the metal for any signs of damage. If there are no issues, the rubber band can be reused or repurposed, while the metal joint can be set aside for future use.
In summary, to disassemble a rubber band metal joint, use needle-nose pliers to carefully detach the metal piece from the rubber. Pay close attention to the type of joint and handle it with care to avoid any damage. Once the joint is removed, assess the condition of both the rubber and the metal for any damage before proceeding with their use.
These steps should help you effectively disassemble a rubber band metal joint.