Do you know what are the ways of spring shock absorber installation?

At present, the use of fans has been very extensive, in the air conditioning units, fire fighting facilities, exhaust systems, ash removal suction system, the use of fans indispensable. But when the fan is installed in the room or roof, because of the vibration analysis and rapid cyclone noise caused by the operation will endanger the surrounding natural environment, and even lead to damage to people, so the need for vibration damping solution.
At this stage, the spring shock absorber has become a key component of machinery and equipment, many friends of the fan spring shock absorber model selection method lack of mastery. In fact, there are many types of fans, we can generally select the fan spring shock absorber according to the installation method of the fan, the net weight of the fan operation, focusing on the condition, the fan speed ratio, the total number of shock absorbers installed in this good number of factors.
Fan installation method can be divided into lifting and floor installation.
1 . Lifting fans need to select hanging spring shock absorbers.
2 . The vertical spring shock absorber is selected for floor-mounted installation.
The spring shock absorber is installed under the base of the equipment or under the base of the fan, and the base is a prefabricated concrete structure plate, which can make the bearing force of multiple shock absorbers installed under the plate uniform, reduce the amplitude of mechanical equipment, and absorb vibration with the help of the base mass digestion. In addition, the spring shock absorber installation should be based on the size of the exhaust volume of the fan to clarify the total number of installations, but not less than four.
The model selection of spring damper installation needs to go through clear driving force measurement, and the type specification model and total number of vibration dampers cannot be changed casually during engineering construction. When the shock absorber is installed in the shock absorber plate, it should be ensured that it is in the middle of the pre-buried hole, not to be deviated, and to maintain the placement surface flat, so that the shock absorber bearing is proportional to the force.