Teflon corrugated compensator model and parameters

Teflon corrugated compensator model and parameters
The tetrafluoro corrugated compensator installed on the pipeline should be set at a place where the fluid pressure is relatively stable and at a certain distance from the source of fluctuation, not at the dead end of the horizontal pipeline, installed at a place where it is easy to repair and adjust, with enough space around. In the vessel body above the liquid level of the gas phase space, can also be installed in the connection point is located in the pressure vessel gas phase space of the pipeline. For the PTFE corrugated compensator that may be blocked or corroded by materials, set a rupture disc in front of its entrance, and in the middle of the PTFE corrugated compensator and rupture disc, add an inspection valve, and take anti-blocking measures such as anti-blowing, heat tracing or heat preservation on its entrance pipeline.
 
Lining material: PTFE
Nominal diameter: DN25~1000(mm)
Nominal pressure: Ultimate vacuum
Operating temperature: -20~180℃
Connection method: flange
Production length: 100~180 (mm)
 
Applicable medium: strong acid, strong alkali, strong oxidizing medium
For containers and equipment containing flammable, toxic and viscous media, a PTFE corrugated compensator can be installed in front of the PTFE corrugated compensator, but the circulation area of the PTFE corrugated compensator cannot be smaller than the small circulation area of the PTFE corrugated compensator, and a lead seal is added to ensure that the PTFE corrugated compensator is in a fully open and normally open state.