Application of flexible waterproof casing in basement.

1 . Pre-embedded basement special Jiangsu waterproof casing with the same wall width, the diameter of the pipe needs to be greater than the diameter of the pipe two diameters. For example, the diameter of the tube is 90mm, the diameter of the pre-embedded casing is 125mm.
 
2 . Pre-embedded basement special Jiangsu rigid waterproof casing of the water stop ring can be used ring-shaped steel around the outer diameter of the casing, no cracks and defects.
 
3 . When the pre-buried waterproof casing is placed and fixed, it may be slightly tilted outward (1%~1.5%). Tilting to the interior slope is strictly prohibited.
 
4 . After the waterproof casing is completed, anti-corrosion treatment should be carried out inside and outside. When anti-corrosion, first brush anti-rust paint twice, and then brush anti-corrosion asphalt paint.
 
5 . When trying to penetrate the pipe, Jiangsu flexible waterproof casing try to make the pipe concentric with the casing. Since the casing has an outward slope, the pipe can be leveled and fixed according to the principle of concentric internal and slightly deviated externally when installing and fixing the pipe.
 
6 . After the pipe is fixed, the gap between the casing and the pipe can be plugged with polyurethane foam on site. Pay attention to foam plugging, polyurethane foam polystyrene should fully fill the gap, there should be no intermittent and broken teeth phenomenon, foam rubber should be embedded in the wall 15 ~ 20 mm. after installing the concave part and complete the anti-corrosion treatment, use asphalt or plastic waterproof grease to fill the wall to the wall, and then cover the polyurethane waterproof coating twice within 150 mm around the casing.
 
7 . When painting the wall or applying waterproof screed, Jiangsu rigid waterproof casing pay attention not to cover the filling area of asphalt or plastic slurry with plaster layer, do not let the plaster layer in contact with the pipe, still filled with asphalt. If the wall needs waterproofing, the waterproofing layer of that part can be made together with the big wall surface.
 
8 . If the waterproof requirement of the underground wall is brick masonry, the wall bushing cannot be embedded directly into the wall, and the masonry is embedded with C20 fine stone concrete of 20mm thickness. Since polyurethane foam has good waterproofing properties and is flexible and adheres well to the pipe wall, it does not affect the waterproofing effect due to expansion and contraction of the pipe. As long as no gap is created when injecting the adhesive and a tight seal is used at the inner seal of the wall and the outer seal, satisfactory waterproofing results can be obtained.